PFAS Analysis by DIN 38407-42 for Water, Wastewater, and Sludge

• Sample Matrix: water, wastewater, and sludge
• Sample Preparation: WAX solid-phase extraction
• Detection Technique: LC-MS/MS

Determination of selected polyfluorinated compounds (PFC) in water-Method using high-performance liquid chromatography and mass spectrometric detection (HPLC/MS-MS) after solid-liquid extraction

DIN 38407-42 is used for the analysis of 10 PFAS in water, wastewater, and sludge. It is not available from Restek but may be purchased from other sources. The full analyte list and recommended products for DIN 38407-42 are provided below. In addition, you can register and directly compare analyte lists and matrices across PFAS analysis methods here or visit www.restek.com/PFAS to explore our technical resources for PFAS analysis.

Analyte List for DIN 38407-42 for PFAS Analysis

PFAS acronyms, compound names, and CAS numbers vary across methods and guidelines, and they also depend on compound form (e.g., neutral vs. salt). The following list uses standardized terminology to allow easy comparison across the methods and guidelines in our comprehensive guide. Please refer to DIN 38407-42 for method-specific nomenclature.

Recommended Products for DIN 38407-42 for PFAS Analysis

PFAS delay column: 5 µm, 50 x 3.0 mm (cat.# 580959 [custom product])

*Note that a regenerated cellulose filter is mentioned in the method. However, nylon and polypropylene are widely accepted filter membrane materials for PFAS analysis.

Discover More Solutions for PFAS Analysis!